Manual Chapter 1

1-14 Read This First
Figure 2. Download Procedure Flowchart (page 1 of 2)
On computer: type A: (or B:) \DOWNLOAD
and press the Enter key
Start
Use communication cable to connect computer
COM1 to UltraSpec analyzer 25-pin connector
Are you using a DOS or Windows
Downloader?
On computuer: place firmware diskette in drive
A: (or B:)
On computer: press the F6 (Comm Config)
key (the Communications Configuration screen
is displayed).
On computer: press the F1 key to accept
Communications Configuration
On computer: select the Start button, then Run.
Type A: (or B:) \LOADFW.EXE and select the
OK button
Use communications cable to connect computer
COM1, COM2, COM3, or COM4 to UltraSpec
analyzer 25-pin connector
On computuer: place firmware diskette in drive
A: (or B:)
On computer: select the Configuration button
(the Communications Configuration screen is
displayed)
On computer: select COM port and 8000/8117,
then select the OK button
DOS Windows
Continue with next step on following page.
On Computer: change communication
configuration if necessary
On Computer: change communication
configuration if necessary