User Manual

ManualsBrandsCompuSTAR ManualsCar alarmRF-P2W902-SP (Remote 2W902R-SP)

www.compustar.com



































Applicable to the following remote(s)

2W902R-SP 2 Way 5 Button LED Remote

Remote FCC ID Number (US Only) IC ID Number (International Only)

2W902R-SP VA5REC500-2WSP 7087A-2WREC500SP

www.compustar.com

Número ID FCC Número ID FCC

(Solamente EE.UU.) (Solamente Internacional)

2W902R-SP VA5REC500-2WSP 7087A-2WREC500SP

Este dispositivo está sujeto a la sección 15 de las reglas de FCC. El funcionamiento está sujeto a las condiciones siguientes;

(1) este dispositivo no puede causar interferencia dañosa.

(2) este dispositivo puede aceptar cualquier interferencia recibida, incluso interferencia que pueda causar mal funcionamiento en el equipo.

CAUTELA: Cambios o modificaciones no expresamente aprobados por la parte responsable del cumplimiento de la norma, pueden anular la autorización

del usuario para operar este dispositivo.

Aplicable a los remoto(s siguientes);



Remoto

Manual de Usuario

Summary of content (18 pages)

PAGE 1
Remote FCC ID Number (US Only) IC ID Number (International Only) 2W902R-SP VA5REC500-2WSP 7087A-2WREC500SP Applicable to the following remote(s) 2W902R-SP 2 Way 5 Button LED Remote www.compustar.com Manual de Usuario Aplicable a los remoto(s siguientes); 7087A-2WREC500SP VA5REC500-2WSP 2W902R-SP Número ID FCC (Solamente Internacional) Número ID FCC (Solamente EE.UU.) Remoto Este dispositivo está sujeto a la sección 15 de las reglas de FCC.
PAGE 2
By Firstech, LLC 2 3 By Firstech, LLC
PAGE 3
Introduction Thank you for purchasing a Firstech system for your vehicle. In order to truly enjoy the benefits of this system, we recommend that you thoroughly review the following manual. Please note that this manual applies to the 2 Way 5 Button LED Remote (2W902R-SP) Regardless of whether you purchased the ALARM IT, START IT, or MAX IT system. This manual also supports the 1WG7R-SP that is included in your new RF Kit.
PAGE 4
Quick Reference 2. If you do not have your remote control, you can put the system into valet by turning the ignition key on and then off five times within 7 seconds. The parking lights will flash once to confirm the system is in valet mode. Shortly after the first flash, the parking lights will flash twice. A remote control is required to take the system out of valet mode. 3.
PAGE 5
Quick Reference Button(s) By Firstech, LLC 8 Duration Quick Reference Function Button Duration One Tap Drive Lock On/Off Half second Turns siren chirps on/off (Note: With the siren chirps off, it will still sound in the event the alarm is triggered). 2.5 seconds Turns the shock sensor on/off. (ALARM IT or MAX IT systems only) Half second Valet mode (see Valet Mode Section for details) 2.5 seconds Option programming menu 1. For use during installation.
PAGE 6
Remote LED Functions and Descriptions Alarm LED Notifications Your remote will communicate to and from your vehicle while in range. The LED will change colors indicating transmission, confirmation, remote start run time and error confirmations.
PAGE 7
Quick Reference Quick Reference Button By Firstech, LLC 12 Duration AdditionalProgramming Function / Description Required Half second no Locks doors and / or arms alarm. 3.5 seconds no Panic/vehicle locater (flashes vehicle’s parking lights and sounds siren and horn) Half second no Unlocks doors and / or disarms alarm. Half second no Aux 1. Triggers the auxiliary 1 output (most commonly used for rear defrost or window roll-down) 2.5 seconds no Trunk pop.
PAGE 8
General System Functions The remote transmitter functions have been predetermined and programmed from the factory. The five button configuration allows for many functions to be performed through a series of tapping, holding and / or multiple presses of buttons. Sending Commands When in range and a command has been sent, the remote will beep and unique LED will flash blue or red. For example, to send a remote start command from the 2 Way remote, hold down the button for 2.5 seconds.
PAGE 9
General System Functions In order to remote start a manual transmission vehicle, the system must first be set in Reservation Mode. Reservation Mode must be set each and every time you want to remote start a manual transmission vehicle. The purpose of Reservation Mode is to leave the transmission in neutral before exiting the vehicle. IMPORANT The transmission must be left in the neutral position. The vehicle’s windows must be rolled up. The vehicle’s door pins must be in working order.
PAGE 10
General System Functions General System Functions Your system is equipped with two additional outputs that can be configured to control windows, open power sliding doors, open a power sliding moon roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized Firstech dealer can set these outputs up accordingly. Using auxiliary outputs to control additional vehicle functions will require additional parts and can be rather labor extensive.
PAGE 11
General System Functions Advanced System Functions The following section reviews advanced system functions. Many of these functions require multiple steps or additional programming by your local authorized Firstech dealer to be active. Your remote comes with an automatic button lock feature. This feature automatically locks all four buttons on your remote after one minute. To unlock just tap any button then tap or hold the button(s) for the command you would like to send.
PAGE 12
Advanced System Functions This remote has the ability to operate a 2nd vehicle with the same system. Note: When in 2nd Car Mode that your LED will flash blue when the buttons are tapped. Hold buttons for 2.5 seconds to enter the Remote Option Menu. Tap the Trunk Button to turn 2nd Car Mode on. Your remote will chirp once for on and twice for off. The remote’s LED will illuminate blue confirming that 2nd car mode is activated. The remote will remain in 2nd Car Mode until you hold the buttons for 2.
PAGE 13
> u ” r ll Advanced System Functions Advanced System Functions 2 Way LCD remote paging To page a 2 Way LCD remote just tap the Red Circle twice. STEP 2: Turn ignition key to the on position and leave the driver s door open. Touch Panel Sensitivity To change touch sensitivity open the driver s door, hold the button on the back of the RPS Touch until the LEDs go out. Release button and tap again. The number of solid LEDs represent sensitivity of touch, 1 being the lowest, 5 the highest.
PAGE 14
Advanced System Functions The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the ignition on/off five times. The Secure Valet Switch is more secure than traditional toggle / valet switches because it requires a two digit code. IMPORTANT: The first two digits of the RPS unlock/disarm pass code will be the default pass code for the secure valet - you do not need to program them independently.
PAGE 15
Remote Coding / Programming Routine (S) IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time. STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7 seconds. The vehicle s parking lights will flash once with the successful completion of this step.
PAGE 16
Alarm Diagnostic Limited Lifetime Warranty While the alarm is armed, the LED will blink slowly. While the siren is going off, the LED will indicate which specific zone was triggered.
PAGE 17
Limited Lifetime Warranty Memo Firstech, LLC. is not RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE that may or may not resulted from the operation of Compustar, Compustar Pro, Arctic Start, Vizion, or NuStart.
PAGE 18
By Firstech LLC Version 1.2(C07) 21903 68th Ave S Kent, WA 98032 8102REUSL001100 / FT-2W902-ES V1 Toll Free : 888-820-3690 Toll Free : 888-820-3690 8102REUSL001100 / FT-2W902-ES V1 By Firstech LLC Version 1.