Programming instructions

Compustar Programming Instructions
To program any compatible Compustar remote control, complete the above installation steps and verify standard
operation.
If the vehicle is equipped with a Push start button on the dash (push buttons in the gear selector lever do not come out
in this manner, nor are they applicable in this case), grasp the button and pull it out of the ignition switch.
Insert the key in the ignition switch and cycle it (5) five times from off to accessory (only one click in the clockwise
direction) and back to off.
The lights will flash once. Press lock or button 1 on the remote control and the lights will flash to confirm
programming. Up to (4) Compustar remotes can be programmed to one unit.
Once all remotes have been programmed, wait for a single light flash confirmation signifying the module has exited
programming mode.
Verify the operation of the new remote.
Insert KeylessGo button back into ignition (if applicable) when finished.
Compustar Drone DR-1000 Connection
Drone power
top row, first pin,
red
Drone ground
bottom row, first
pin, brown
Copyright 2010 Midcity Engineering! 11
DO NOT USE BLUE PORT FOR DRONE CONNECTION.
DRONE DATA CABLE MUST PLUG INTO BLACK PORT MARKED RS232.
!