Installation guide

Page 12
Adjusting the Car Siren Volume:
In order to decrease the chirping volume of the siren, cut the loop located on
the siren.
Adjusting the Shock Sensor Sensitivity:
In order to the shock sensor sensitivity, turn the screw located on the
sensor clockwise. In order to decrease the sensitivity, turn the screw located
on the sensor counter-clockwise. Turning the screw just a small amount can
make a big difference so make sure you recheck the sensitivity after each
adjustment.
Setting
AUX No.
2-9
On
A ccess to pa s s i ve mode through a remote
N on setting o f passive mode Setting o f passive mode
Button II
Button III
All outputs are connecting with
Channel Expander through AUX1.
Button I Button II
Button II Button III
AUX1,
AUX2
Button III
Button IV
Button II-
Button III -
Button IV-
off
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
Output
2 - 1 0
If you take the Channel Expander option of 2-9, the Passive setting of the
remote will change the button functions to operate of the Channel Expander.
The Passive setting of the remote will no longer work as the Passive Arming
function. Therefore, if you need both Channel Expander and Passive Arming
function, you need to choose this option.
Diagnosing Problems with Auto-Start
If there is a problem in auto-starting your car, you will hear three chirps when
you attempt to auto-start the car.
Wait for 2 seconds and the cause for the error will be indicated by the number
of times parking lights flash
Error Number
(# of times parking lights flash)
1
2
3
4
5
6
7
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open
Reservation Off
(Manual Transmission Only)
Page 13