Installation guide

Note : 2-1 Cold start mode requires installation of the temperature sensor.
In the default factory setting, Cold Sensor input works as Remote Start
Activation Input. A Ground pulse to this wire will start the vehicle
2 - 4 With this option, Panic mode becomes Anti-Jacking mode.
The differences between Panic mode and Anti-Jacking mode are:
Page 10
Programming Menu #2 (Security Options)
1 - 7 Turbo mode requires the connection of the emergency brake wire for either
automatic or manual transmission vehicles. With this mode, engine will
continue running for two minutes after key is turned off if the emergency
brake was set before the key was turned off and the foot brake was not
being pressed when the key was turned off.
1 - 8 This feautre is needed for diesel engine when you don’t use glow plug wires.
Feature
Cold Start with Temp Sensor
Timer Start or Minimum Interval
between Cold Starts
OFF
3 Hr
Passive Locking, too
ON
1.5 Hr
No Passve Locking Remote
controller
OFF
OFF
0.5 Sec
0.5 Sec
30 Sec
ON
ON
Latch
Latch
60 Sec
Factory Default
Setting - Button I
Optional
Setting - Button I I
Programming
Method
2 - 1
2 - 2
2 - 3
2 - 4
2 - 5
2 - 6
2 - 7
2 - 8
Passive Arming
Anti-jacking
Ignition Controlled Door Lock
Aux 1 Output
Aux 2 Output
Siren Duration
Feature
Non using of Channel
Expander module
When Option 2-9 is on
Non using of Passive
Mode with remote
Using of Channel
Expander module
Using of Passive
Mode with remote
Channel Expander
Passive Arming with the
Channnel Expander
Option
Programmer
(CM3 -Series)
OFF ON
Programming
Method
2 - 9
2 - 1 0
Page 11
Panic Mode
IV for 2 seconds
1.5 minutes
Starter-Kill
Activated immediately
N/A
Button
Siren
Installation required
Starter Kill
Ignition Kill
Anti-Jacking Mode
IV for 2 seconds
1.5 minutes
Ignition-Kill
N/A
Activated immediately if key is not on.
If key is on, activated in 30 seconds
after pressing the Button I V
2-5 Automatic Transmission Vehicle: This programmable option enables your
vehicle to automatically lock the doors upon starting the vehicle with a key.
In addition, the vehicle will automatically unlock the doors upon pulling the
key out from the ignition. This option must be chosen at the time of installation.
Manual Transmission Vehicle or Turbo Mode: This Programmable option
will locks the doors after starting the vehicle with a key and the
emergency brake is released.
2-6 & 2-7
You can program the duration between 1 to 99 seconds.
You can program the “Latch Mode” also.
Setting
Contents
2-9
Off
Pluse
Latch
Pluse
Latch
On
2 - 6
2 - 7
o f f
o n
o f f
o n
1-99, Latch
1-99, Latch
2-9 If you need more than 2 Aux outputs, you can interface the CM3000 with
Channel Expander for 7 Aux outputs. If you take this Channel Expander option
and you turn on the Passive setting of the Nu4000R, the four buttons of the
Nu4000R operate these 7 outputs instead of normal button functions such as
arm/disarm or start/stop. Refer to the manual of the Channel Expander.