Installation guide
-
If you hear a long chirp, you are going out of programming mode,
please go back to Step1.
-
If you want to change more options, go back to Step1.
Programming
Programming Menu 1
Programming Menu 2
Option Selection
Factory Setting
Option Selection
Default Setting Selection
6 Button Remote
(Trunk+Start)-
(Trunk+Stop)-
(Stop)-
Lock
Unlock
(Start)-
4 Button Remote
(I+II)-
(I+IV)-
(IV)
( I )
( II )
( III )
Page 8
Resetting a l l of Menu #1 or Menu #2 of Programming Options
to the factory default settings
-
if you are not sure about current
programming, change everything to the factory settings and start again.
1.
Resetting a l l of Menu #1 to the factory setting
Step 1:
Press buttons
( I + I I )
simultaneously for 2 seconds. This will be
confirmed by a siren chirp and a one-time flashing of the parking light.
Step2:
Press button
I I I
once. This will be confirmed by a car chirp and
parking light flash. Press button
I I I
again. You will be confirmed by a car chirp
and parking light flash again. Press button
I I I
third time. You will be confirmed
by a car chirp and parking light flash third time. A few second later, your car will
chirp and parking light flash three times rapidly to confirm the resetting.
2. Resetting
all
of Menu #2 to the factory setting.
Follow the same steps above except that you press buttons
( I +
I V
)
for 2
seconds at the Step 1 instead of buttons
( I + I I )
.
The procedures will be same as the 4 button remotes except the use
of the different buttons.
Option Programming for Six Button
(ONE WAY)
Remotes
Programming Menu #1 (Auto-Start and Door Lock Options)
Remote-Pager Programming Menu Options
Note :
1 - 1
Some vehicles such as Mercedes-Benz and the Lexus ES300 require you to
unlock the car to disarm the factory alarm before remote starting the vehicle.
Activating this feature will unlock the vehicle for a brief second in order to
disarm the factory alarm before auto-starting the vehicle remotely then
lock after starting.
1 - 4
This feature unlocks the driver’s side door lock with the first unlock pulse.
A second unlock pulse is need to unlock the rest of the car doors.
Page 9
I
n orde
r
f
or this
f
eatu
r
e to operate, the
i
nstal
l
er mu
s
t use the
2
n d
U
nlock
W
ire (O
r
/
B
k
w
ire of Connector 4).
I
solate the d
r
iver
’
s doo
r
actuator
f
rom the
r
est o
f
the other doors. Call us
f
or the techn
i
cal suppo
r
t i
f
you are not
sure about this.
I m p o r t a n t !
Feature
20 sec
Diesel Preheating Time
3~99 sec
Option
Programmer
(CM3 -Series)
OFF ON
Programming
Method
1 - 8
Feature
Unlock Before, Lock After Starting,
Lock after remote start
Door Lock / Unlock Pulse Duration
Min. Crank Time for the
Alternator Sensing
Driver’s Priority Unlock
Double Pulse Unlock
Turbo
OFF
0.8 sec
0.8 sec
ON
2.5 sec
1.0 sec
Remote
controller
OFF
OFF
OFF
ON
ON
ON
Factory Default
Setting - Button
I
Optional
Setting - Button
I I
Programming
Method
1 - 1
1 - 2
1 - 3
1 - 4
1 - 5
1 - 6
1 - 7