INSTALLATION GUIDE NuAS Module [ CM 3000 ] INSTALLATION GUIDE CM3000 www.NUSTART.
TABLE OF CONTENTS Page 2 - Wiring Diagram Page 4 - Switch and Jumper Settings Page 6 - Installation of AM,FM or SS Antennas Page 7 - Option Programming for Four Button Remotes Page 7 - Option Programming for Six Button Remotes Page 8 - Remote - Pager Programming Menu Options Page 9 - Diagnosing Problems with Auto-Start Page 13 Page 3
Notes Wiring Diagram CN1 OFF / ON Alt/Tach 15(25) / 25(45) Gasoline(Diesel) SW CN12 [ 4 3 2 1 (-) (+) CN11 Tx Rx [ 3 2 1 (-) Temp CN10 (+) [ 4 3 2 1 Led (+) Knock CN9 (-) [ 2 1 2nd 1st Tach Learning Switch Antenna Temp Sensor Remote Paging System Optional Sensor CN8 6 Yellow 8 Black 2 : Pk ing Light 4 : Accessor y 6 : Starter 8 : Ground 2 . Starter Kill/Anti-Grind-Violet at CN1 supplies a negative 250mA output when the system is armed.
If you program Dome Light Rearm option, The Violet wire of CN5 supplies a ground pulse before Lock and a pulse after remote start. The Dome Light Rearm Option is to simulate Opening the door and pressing the factory lock button for factory arming. 12 . Learning Tach/Injector Wire: Start the vehicle with the manual key and let the engine idle down. The next step is to press the black tachometer button. The car siren will chirp once to confirm the tach was learned.
- - If you hear a long chirp, you are going out of programming mode, please go back to Step1. Remote-Pager Programming Menu Options Programming Menu #1 (Auto-Start and Door Lock Options) If you want to change more options, go back to Step1. Resetting all of Menu #1 or Menu #2 of Programming Options to the factory default settings - if you are not sure about current programming, change everything to the factory settings and start again. 1.
1-7 Turbo mode requires the connection of the emergency brake wire for either automatic or manual transmission vehicles. With this mode, engine will continue running for two minutes after key is turned off if the emergency brake was set before the key was turned off and the foot brake was not being pressed when the key was turned off. 1-8 This feautre is needed for diesel engine when you don’t use glow plug wires.
2-10 If you take the Channel Expander option of 2-9, the Passive setting of the remote will change the button functions to operate of the Channel Expander. The Passive setting of the remote will no longer work as the Passive Arming function. Therefore, if you need both Channel Expander and Passive Arming function, you need to choose this option. Setting AUX No.
Page 14 Page 15
