User`s guide

©
2001
Firstech, Inc
.
Page
6
10.
(I+III)
1/2 sec
Valet Mode
–
on/off
Off
11. (II+III) 1/2 sec Passive Arming – on/off Off
12. (II+IV) 1/2 sec Timer Start Mode - on/off Off
13. (III+IV) 1/2 sec Turbo Mode - on/off Off
14 (I+III) - 2 sec Shock Sensor – on/off On
15 (II+III) - 2sec Vibration Mode – on/off Off
16. (I+II) - 2 sec Programming Menu 1
17. (I+III) - 2 sec Programming Menu 2
Note: ( ) means simultaneously pressing the buttons
Note: ( ) – means simultaneously pressing the buttons for 2 seconds.
Remote-Pager Learn Routine and/or Adding a One Way Remote
Your Antenna Module (ANT-2WSS) has been programmed for your specific remote-pager at the time of installation. If you replace or add an additional ONE
WAY REMOTE (ANT-2WSS can be programmed for one remote-pager and 1 one- way remote), please perform the following procedure:
Step 1: Take the AA battery out from the remote-pager.
Step 2: Activate Valet/Programming mode by manually turning the ignition on and off five times with car key within a 10 second period.
The parking light will
flash once with successful completion of this step.
Step 3: Within a 10 second period after cycling the ignition for the 5
th
time, insert the AA battery into the remote-pager. The car parking lights wil
l flash once
to confirm that the transmitter has been programmed.
Important! Note that you can program only one remote-pager unit for a single antenna module. The new programming will erase any previous remotes that
were learned.
Remote-Pager Factory Reset Routine
The remote-pager uses Spread Spectrum Technology (SST). In rare cases, if you press the remote-pager buttons multiple times outside of the transmitting
range of the Antenna module, the remote-pager may go out of synchronization. In this case, reset the remote-
pager by removing the AA battery and reinsert it
back into the remote-pager. Please perform this procedure in close proximity to the vehicle.
USING YOUR SYSTEM
Your CompuStar 2WSSR system has many different modes and functions that can be activated by using your remote-pager unit.
Alarm Mode
You can arm or disarm alarm mode by pressing Button I for a ½ second or 2 seconds. A bolted padlock icon will appear on your CompuGLO LCD indicating
that your car is armed and a lock icon will appear showing that your car doors are locked. Also, your car will chirp when you arm or disarm your car.
Press Buttons (I+II) for a ½ second to make your car siren mute when arming or disarming your vehicle. A car siren icon will disappear on the bottom left-
hand
corner of your CompuGLO LCD indicating that you are in car siren mute mode. Keep in mind that your car siren will still activate for all other modes (i.e.
panic, alarm, shock sensor) regardless of whether or not your car siren is in mute mode. The car siren will be mute only when arming or disarming your
vehicle.
When alarm mode is armed, the following will trigger the remote-pager security alerts:
?? Unauthorized car door opening will activate the car siren for 30 to 60 seconds and the parking lights will flash for 60 seconds. The remote-pager wi
ll
be notified audibly and the door icon will appear in the CompuGLO LCD. Press Button I for a ½ second to turn off the car siren and flashing lights.
Repeat this step (press Button I for a ½ second) again to disarm alarm mode.
See th
e illustration for a
typical ignition harness of a
vehicle