User`s guide

©
2001
Firstech, Inc
.
Page
12
Most likely, you
did not push Button
II
for the required 2 seconds. Pushing Button
II
for only a ½ second engages the optional auxiliary function instead of auto
-
start.
For manual transmission cars, the vehicle must be in reservation mode before you can auto-start your car remotely. If your remote-
pager door icon flashes and
beeps three times along with your car’s parking light flashing three times when you try to auto-start your manual-transmission car, reservation mode has not
been set. Please see page 11 of this manual for instructions and important requirements to activate reservation mode. Note that your car will not auto-start if
you are in Valet Mode or if your Valet Switch is turned on despite being in reservation mode.
Another reason maybe that you are in Valet Mode. If there is a ZZZ icon on your remote-pager unit, you are in this mode and all the functions of the
CompuStar 2WSSR are disabled except for keyless entry. Press Button (I+III) simultaneously for a ½ second to deactivate Valet Mode.
If there is a problem in auto-starting your car, you will hear three chirps from your remote-pager when you attempt to auto-start the vehicle. After waiting two
seconds, the diagnosis for the auto-start error will be indicated depending on the number of times the car chirps and parking lights flash. For example, 4 car
chirps and parking light flashes indicates that the car did not auto-start because the trunk was open. Please see page 7 of the user’s manual for the error
diagnosis table.
My car is armed in alarm mode and my remote-pager is not working or I do not have my remote-pager. How do I avoid triggering the CompuStar starter kill
function so I can drive my car?
Unlock the car door with your manual key, which will trigger the car’s siren and parking lights. You must manually override the CompuStar security and auto-
start functions by putting the car into Valet Mode. This mode will disable all the functions of the CompuStar except for keyless entry.
In order to enter Valet Mode, cycle the ignition key from the off position to the on position 5 times within a 10 second period. You are now in Valet Mode and
have disabled the CompuStar 2WSSR security system except for keyless entry.
I keep banging on my RPS (remote paging system) sensor but it is not working.
RPS se
nsor is usually located on the outside edge of the driver’s side front window shield and detects high frequency vibration. Therefore, in order to properly
activate RPS, the user must produce a high-frequency sound by tapping with a car key where the RPS sensor is located. Simply pounding on the front
windshield with your hand will not produce the required high frequency vibration and therefore will not activate the RPS system.
How do I deactivate my RPS audible and visual (telephone icon) paging alerts on my remote-pager?
Press Button I, II, III or IV for a ½ second to deactivate the RPS paging alerts.
My remote pager unit is not beeping audibly when I push the buttons.
Check to see if you are in remote-pager vibration mode by observing a vibration icon that appears continuously in the upper left-hand corner of your
CompuGLO LCD screen. Press Buttons (II+III) for 2 seconds to deactivate vibration mode and the vibration icon will disappear.
My car is not chirping when I arm or disarm alarm mode.
Check to see if you are in silent arm / disarm mode by observing a car siren icon in the bottom left-hand corner of your CompuGLO LCD Screen. Press
Buttons (I+II) for a ½ second to deactivate the car siren when arming/disarming your vehicle and the car siren icon will disappear. Keep in mind that your car
siren will still activate for all other modes (i.e. panic, alarm, shock sensor, etc) regardless of whether or not your car siren is in mute mode.