User`s guide

0 Fast Draft (Model Z03 only)
1DP
2 DP Text
3 NLQ
Buffer Terminating Conditions
The following controls cause buffered data to be released for printing:
v Carriage Return
v Line Feed
v Reverse Line Feed
v Form Feed
v Horizontal Tab (if there is print head movement)
v Vertical Tab
v Backspace
v Set 1/8 Inch Line Spacing
v Set 7/72 Inch Line Spacing
v Set Graphics Line Spacing
v Select n/72 Inch Line Spacing
v Invoke Text Line Spacing (if the line spacing is changed)
v Relative Move Right
v Relative Move Left
v Relative Move Baseline
v Shift In/Condensed Print
v Shift Out/Double-Wide Print
v Device Control 4/Cancel Double-Wide Print
v Begin Subscript/Superscript
v End Subscript/Superscript
v Begin Double-Strike Print
v End Double-Strike Print
v Begin Emphasized Print
v End Emphasized Print
v Set Presentation Highlight
v Continuous Overscore
v Auto Underscore
v Device Control 2/Select 10 CPI
v Set 12 CPI
v Proportional Space Mode
v Change Font
v Normal Density Bit Image Graphics
v Dual Density Bit Image Graphics Type 1
v Dual Density Bit Image Graphics Type 2
v High Density Bit Image Graphics
v Set Initial Conditions
v Select Score Line (2381 and 4247 only)
v Unidirectional Printing
v Set Horizontal Margins
The following conditions also cause buffered data to be released for printing:
v Parallel -INIT
v Automatic Line Wrap
An automatic line wrap consists of a carriage return and line feed inserted after the maximum number of
characters has been printed on a line. The next character is then printed at the left margin on the
following line. Automatic line wrap occurs for text data but not for bit image graphics.
38 Programmer Manual