User`s guide

P1 Parameter Byte for 4201 III XL Emulation
Bit On Off
7 Discard Byte Ignore Process
6 Reserved
5 Alarm Disable Enable
4 Auto CR CR on Vertical Movement No CR on Vertical Movement
3 Auto LF Auto LF after CR No Auto LF after CR
2 Form Length 12 inch forms 11 inch forms
1 Zero Slashed Zero Normal Zero
0 Character Set PC Char Set 2 PC Char Set 1
P2 Parameter Byte for 4202 III XL Emulation
Bit On Off
7 Discard Byte Ignore Process
6 Print Language CP 850 Multilingual CP 437 ASCII
5 Direction Unidirectional Bidirectional
4 20 Condense 12+Condense = 12 CPI 12+Condense = 20 CPI
3 Select NLQ NLQ Gothic NLQ Courier
2 Form Feed Ignore FF if at TOF Honor all FF
1 Line Length 8 inch line 13.6 inch line
0 Sheet Feeder Enable Disable
Notes: The following parameters are changed to the manufacturing default by the INIT control byte in the
ASCII Configuration Menu only:
v Characters Per Inch (CPI)
v Lines Per Inch (LPI)
v Maximum Print Position (MPP)
v Maximum Page Length (MPL)
v Print Language
v Print Quality
v NLQ Typeface
v Character Set
v Printer Compatibility 3 - Automatic Line Feed on Carriage Return
v Printer Compatibility 4 - Automatic Carriage Return on Line Feed
v Printer Compatibility 5 - Form Feed Suppression
v Printer Compatibility 8 - Slashed Zero
v Printer Compatibility9-20CPI
v Alarm Control
The following parameters are NOT modified by the INIT control byte:
v Values in Any Custom Set
v Active Custom Set
v Default Attachment Selection
v Rear Tractor Use
v ASCII Configuration:
– Emulation Mode
– Printer Compatibility 6 – Init
Chapter 1. Personal Printer Data Stream (PPDS) 25