User Manual Part 2

87
Adjusting the Tear-Off Position
HEX DUMP NO
↑
TEAR ADJUST: - 30
→
or
←
TEAR ADJUST: ...
→
or
←
TEAR ADJUST: +360
→
or
←
↓
CUT ADJUST xxx
TEAR ADJUST: xxxx
These values adjust the distance between the Tear-Off Perforation and the
Tear-Off Bar. The values correspond to 1/180 inch units, i.e. the tuning
ranges between -1/6 and 2 inch.
0
is the default value.
See also “How to Use the Tear-Off Function”, later in this Chapter.
Adjusting the Cut Position
This selection appears only if the cutter option is installed.
TEAR ADJUST xxx
↑
CUT ADJUST: - 30
→
or
←
CUT ADJUST: ...
→
or
←
CUT ADJUST: +360
→
or
←
↓
STORE? QUIT
CUT ADJUST: xxxx
These values adjust the position in which the paper is cut. The values correspond
to 1/180 inch units, i.e. the tuning ranges between -1/6 and 2 inch.
0
is the
default value.