User guide

Mar 01
9-10 Compuprint PageMaster 280 User Guide
Solving Offset Output Tray Problems
2. Make sure that the offset output tray is firmly attached to the printer and that the wiring
attaching the paper diverter to the printer is intact.
If the offset output tray is firmly attached and the wiring is intact but the offset output tray is
still inoperative, return to the installation procedure and carefully repeat all of the installation
steps.
3. If the offset output tray is still inoperative after reinstallation, remove it from the printer so
you can run tests on the printer alone.
4. Print a few sheets of paper to the main output tray to make sure the printer is still opera-
tional.
• If the printer is operational when the offset output tray is not attached, contact either
your sales representative or a service technician and report your problem.
• If the printer is not operational when the offset output tray is not attached, refer to
Chapter 5: Troubleshooting for procedures to correct printer problems. After correcting
the printer problem, return to this chapter to reinstall the offset output tray.
Clearing an Offset Output Tray Paper Jam
If an E8 error code precedes the error message on the first line of the control panel display, paper
has jammed at the offset output tray. Use the following procedure to clear a paper jam in this loca-
tion:
1. Pull on the hand grip on the rear of the offset output tray to open the rear cover.
2. Remove any jammed paper from the interior of the offset output tray.