User guide

Apr 01
9-8 Compuprint PageMaster 280 User Guide
Testing the Offset Output Tray
13. Attach the paper guide near the paper exit slot.
14. Insert the plug of the power cord into the AC outlet and turn the printer on by pressing
[ I ] on the power switch on the right side of the printer.
15. Check the display to make sure the printer is ready for printing.
NOTE: If an error message is shown when you turn the printer on, refer to Chapter 5:
Troubleshooting.i
Testing the Offset Output Tray
After installing the offset output tray, use the following test procedure to verify that it is operating
correctly.
1. Turn the printer on by pressing the [ I ] on the power switch on the right side of the printer.
2. Once the printer has warmed up and displays the “Ready” message on the control panel dis-
play, use any software application to print a few sheets to the offset output tray.
3. Ifthefeederdoesnotfeedpaperorifthecontrolpaneldisplaysanerrormessage,refer
to“Solving Offset Output Tray Problems” on page 9-9.
1
2