User manual

Printer Setup
A78408356-00346
Setup Parameter Values Description
after tear When pressing the PARK key or receiving a
park command via software:
2. If the current page is not empty (there is
printing data or paper movement
commands have been issued), a form
feed is performed.The paper is moved to
the tear-off position.
3. The P1, P2, P3 and P4 leds blink.
4. When the ON LINE key is pressed the
printer parks the paper
TEAR MODE
(only MDP40T and
MDP40C models)
auto 1s, auto 2s,
auto 3s, auto 4s,
auto 5s, manual,
no tear/reverse
Selects the way the tear mode is performed.
Selecting
auto 1s, auto 2s, auto 3s,
auto 4s,
or
auto 5s
, the printer moves the
paper in the tear-off position and back to the
printing position after the corresponding number
of seconds. Selecting manual, the tear-off is
performed manually, pressing the ON LINE key.
Selecting
no tear/ reverse
, the printer does
not perform the tear-off function (this is useful,
when printing on labels).
MANUAL LOADING enabled, disabled Selects the manual loading mode. Setting it
to
enabled
the printer loads any kind of
document according to the described
procedures. Select
disabled
, when a more
precise paper alignment is necessary. With
this selection it is not possible to load
documents with a width of less than 90 mm.
ALIGN MODE fast, normal Selects the paper alignment mode. Selecting
fast
the printer performs less checks on the
alignment, whereas, if you need a particularly
precise alignment of the documents, select
normal
.
GAP MODE
(only MDP40T and
MDP40C models)
auto, fix Selects, whether the print gap is sensed for
each inserted sheet (
auto
) or only for the
first sheet after the printer power on (
fix
).
The print gap is sensed separately for the cut
sheet and the fanfold paper.