User manual

Printer Setup
A78408356-003 41
Setup Parameter Values Description
PASSBOOK LENGTH
(MDP40B and
MDP40C models
only)
auto
setup
Selects the passbook length setting mode.
Selecting
auto
the length of the passbook is
read and set automatically by the printer,
independently from the passbook length set
by menu or software command.
Selecting
setup
the length of the passbook
is set by the user in the menu or by means
of a software command. This selection
allows a particularly accurate printing and is
especially useful when printing on
passbooks with horizontal fold.
The values range between 99 and 210 mm.
To set the values combine the numbers
considering that the first line corresponds to the
hundreds, the second line to the tens and the
third line to the units. See the example below.
Example:
How to set the passbook length to 150 mm:
PASSBOOK WIDTH
(
(
setup ( ) auto
mm Minimum = 99 Maximum = 210 Current = 176
0123456789
( )
(
(
( )
( ) ( ) ( ) ( ) ( )
(
(
( ) ( ) ( ) ( )
(
(
( ) ( ) ( ) ( ) ( ) ( ) ( ) ( ) ( )
Setup Parameter Values Description
SECURITY MODE
(MDP40B and
MDP40C models
only)
enabled, disabled Enables or disables the security actions that
assure protection against paper jams. If
disabled, the paper handling is faster.
AUTO GAP OFFSET -0,075 mm,
-0.050 mm,
-0.025 mm,
+0.000 mm,
+0.025 mm,
+0.050 mm,
+0.075 mm,
+0.100 mm
Sets the automatic gap offset to one of the
given values.
GET EDGE QUOTE 0/2”, 1/2”, 2/2”,
3/2”, 4/2”, 5/2”,
6/2”, 7/2”
Sets the position in which the left paper edge
is checked. If set to 0, the check is
performed at the first line. The other values
correspond to the physical distance from the
first line.