User manual

Printer Setup
A78408356-003 39
Setup Parameters
The following is a listing of the setup parameters.
Configuration Sheet
Setup Parameter Values Description
RESTORE TO MFG No
all
config
prog.1, prog. 2,
prog.3, prog 4
The selected values are not set to factory
defaults.
The values set in all printer setups are reset to
factory default values.
The values set in the configuration setup are
reset to factory default values.
The values set in the corresponding program
setup are reset to the factory default values.
The programs 3 and 4 may be selected only
for the MDP40T and MDP40C models.
PROGRAM progr.1, progr.2,
progr.3, progr.4,
progr.1/3,
progr.2/4
Defines the default Program Setup or Setup
couple. The program couples may be selected
only if the same emulation has been selected
for the two setups. The programs 1/3 and 2/4
may be selected only for the MDP40T and
MDP40C models.
PROGRAM LOCKED disabled
enabled
Locks the program setup selection. In case the
lock is ‘enabled’ the program setup cannot be
changed pressing the PROGRAM key.
ERROR BUZZER 1 beep
no beep
Selects the behavior of the buzzer in case of
an error.
INTERFACE TYPE parallel
serial
automatic
auto+blink
Selects the interface type. In case of
‘automatic’ the interface type is selected by
the printer depending on data coming from
host. When the
auto+blink
item is selected,
the P1 and P2 leds blink to indicate which
interface is selected: P1 blinks when the serial
interface is selected, whereas P2 blinks, when
the parallel interface is selected.
INPUT BUFFER 1 Kb, 8 Kb,
16 Kb, 32 Kb
Selects the buffer size.
IGNORE PE enabled
disabled
Selects whether the printer signals the paper
empty condition (
disabled
) or not (
enabled
).
AUTOFEED SIGNAL disabled
enabled
The parallel interface uses (
enabled
) or does
not use (
disabled
) the AUTOFEED signal.
SLCT-IN SIGNAL disabled
enabled
The parallel interface uses (
enabled
) or does not
use (
disabled
) the SELECT-IN signal.