User manual

Printer Setup
A78408356-003 35
The printer setup forms contain all printer parameters and the
values that can be set. The current value is indicated by an
asterisk (*).

For a detailed description of the parameters and the settings see “Setup
Parameters” later in this manual.
Each printer setup form is identified by a marker in the upper left
corner of the page as follows:
Configuration Setup
Program 1 Program 3
MDP40T and MDP40C only
Program 2 Program 4
MDP40T and MDP40C only
If you press the
LQ
key:
The printing of the printer setup forms starts. The forms are printed
according to the selection made with the
PROGRAM
key.
If you select one of the Program couples
P1/P3
or
P2/P4
(MDP40T and
MDB40 C models only)
, you can define one parameters set for printing
on cut sheets and one for fanfold.
P1
and
P2
define the values for
printing on cut sheets, whereas
P3
and
P4
define the printing
parameters for the fanfold paper.

The program couples may be selected only if the same emulation is
selected for the two programs.
The selection of the Program Setup is made simply pressing the
PROGRAM
key. When passing from one Program Setup to another, the
printer resets before setting the parameters as defined in the new
program setup.