User manual

5 Initializes printer to factory settings. The download font is initialized. If

parameters are specified, they will overwrite the default settings. This

command will only copy the default settings from ROM, add parameter

changes, if any, and store in working RAM; the data stored in the macro’s non-

volatile RAM will not be affected.

254 Initializes printer to user-default settings. The download font is initialized. If

parameters are specified, they will overwrite the default settings. This

command will change data stored in the selected macro. It will copy data from

the selected macro, add parameter changes, if any, and store in working RAM

and in the selected macro. It will also change the default macro to the value of

parm 3.

255 Initializes printer to default settings. The download font is initialized. If

parameters are specified, they overwrite the default settings. This command

will change data stored in the macro’s non-volatile RAM. It will copy default

settings from ROM, add parameter changes, if any, and store in working RAM

and all macros. It will also set the default macro to disable.

The

parameter specifies the printer for which the following parameter bytes

are intended. If the ID does not address your printer, the mode bytes that follow

are ignored. The ID values are Hex = B6, Dec = 182.

parm

Specifies the following functions:

Bit Not set Set

7 Discard byte Process this byte Ignore this byte

6 Reserved

5 Alarm Alarm enabled Alarm disabled

4 Automatic CR No CR on vertical movement CR on vertical movement

3 Automatic LF No LF after CR LF after CR

2 Page length 11 inches 12 inches

1 Slashed zero Zero without slash Zero with slash

0 Character set CS1 CS2