User manual

19
Where d
1
is equal to:
1
[(vertical position) – (current position)]
x
(
defined unit
)
MOD
256
For negative (left) movement:
Where d
2
is equal to:
1
[(current position) – (vertical position)]
x
(
defined unit
)
32768-INIT
256
Where d
1
is equal to:
1
[(current position) – (vertical position)]
x
(
defined unit
)
32768-MOD
256
The default unit is 1/360 inch. The new position is measured in defined units from the
current position. Moving the print position below the bottom-margin position, it moves
the vertical print position to the top-margin position on the next page ejects a cut
sheet, if loaded.
The printer ignores this command if this one would move the print position more than
179/360 inch in the negative direction or if the command would move the print
position in the negative direction after a graphics command is sent on the current line
or above the point where graphics have previously been printed. The command would
move the print position above the top-margin position.