User manual

ESC / {m}
Select the Vertical Format Unit (VFU) channel (only
EPSON mode)
1B 2F {m}.
27 47 {m}
0≤ m ≤ 7
The {m} parameter specifies the VFU channel number.
VT
Advances paper to the next vertical tap stop of the
selected VFU channel.
0B
11
In IBM mode, this code will be executed like a LF code, if the tab stop follows the
bottom of form position or if the current position is beyond the last tab stop or if
no tab stop has been sent by the ESC B. In EPSON mode, the vertical tabulations
that should be executed are referred to the VFU channel selected by the ESC / {m}
command. If no VFU channels have been selected, the printer assumes as default
the channel 0. This code will be executed like a FF code if the tab stop follows the
bottom of form position or if the current position is beyond the last tab stop. It will
be executed like a LF code, if no tab stop has been set.If the vertical tabulations
have been reset , the LF will be not executed.
ESC b {m} NUL
Cancels all current vertical tab stops set in the
specific VFU channel (only EPSON mode).
1B 62 {m} 00
27 98 {m} 0
0 ≤ m ≤ 7
The {m} parameter specifies the VFU channel number.
ESC R
Sets horizontal and vertical tab stops to default
values (only IBM mode).
1B 52
27 82
This command sets horizontal tab stops every eight colums starting from column
9, and cancels all vertical tab stops.
Appendix A
A.12
A78401745-001