User manual

Function 56 PARITY BIT
Selects the parity for the serial interface.
01 NONE
02 ODD
03 EVEN
04 IGNORE
Function 57 STOP BIT LENGTH
Selects the number of stop bits for the serial interface
01 1
02 2
Function 58 CTS
Overrides CTS (clear to send) control on the serial interface.
01 INVALID
02 VALID
When you wish to leave the current Printer Setup procedure, press the
PITCH/EXIT MENU
key, the new function/value settings will be stored and you exit
the Setup mode. The display show:
SETUP END
Setup Listing Printing
If you can verify the current printer settings on the Setup listing, proceed as
follows:
◆
Turn the printer Off and then On.
◆
Check that the paper is present in the printer and then, press the
QUIET/ENTER MENU
key about 5. sec. (FUNCTION & MENU message will
be displayed).
◆
The printer prints the current listing and then returns to the Normal print
mode.
Chapter 3
3.22
A78401745-001