User manual

The Printer Setup
The Printer Setup procedure allows you to set most of the printer’s
functions.You can perform this Printer Setup procedure via the operator panel. The
keys scan and select the available functions and their values while the display
shows the related messages.
Entering Printer Setup
◆
Turn the printer on and the basic check is performed. You should see the
following message:
INITIAL CHECK OK
◆
Do not press any function key and the display will show the following
message automatically after a few seconds:
ON LINE USER 1
◆
Press the
ON LINE/←
key to switch the printer off line, the display will show:
OFF LINE USER 1
◆
Press the
QUIET/ENTER MENU
key to enter the Setup mode.
Moving within the Printer Setup
Function Selection Mode
Press the
ON LINE
/
←
key to enter the Function Selection Mode (the displayed
function blinks). Press the
↑
or
↓
keys to scan the functions forwards or backwards.
When you wish to confirm the displayed function, press the
LOAD-PARK/→
key, the
displayed function will be selected (it stops blinking) and enter the Value Selection
Mode.
Value Selection Mode
Press the
LOAD-PARK
/
→
key to enter the Value Selection Mode (the displayed
function value blinks). Press the
↑
or
↓
keys to scan forwards or backwards the
values. When you wish to confirm the displayed value, press the
ON LINE
/
←
key,
the displayed value will be selected (it stops blinking) and enter the Function
Selection Mode
Chapter 3
3.10
A78401745-001