User manual

2.
Remove the carriage cover,
then manually move the
carriage to the center of the
printer. Set the gap set lever to
its rearmost position 6 to
provide the maximum
distance between the print
head and the platen for smooth
installation (see forward
"Gap Adjustment Between
The Print Head And Platen",
in this chapter..)
3.
Before installing the ribbon
cartridge, turn the ribbon
winding knob in the direction of
the arrow to take up slack in the
ribbon.
4.
Position the ribbon cartridge on
the carriage and push it down
following the direction of the
arrow. Rotate the ribbon
winding knob again to take up
slack in the ribbon.Manually
move the carrier horizontally to
ensure that the ribbon winding
knob rotates properly
Carrier Cover
Gap Set Lever
Ribbon Winding Knob
Carrier
Chapter 2
2.4
A78401745-001