User manual

ESC e {n} {m}
Spaces backwards relative dot position (only IBM
mode).
1B 65 {n} {m}
27 101 {n} {m}
0 ≤ n, m ≤ 255
This command causes the print head to be moved to a dot position calculated as
{n+m*256}/120 inch on the left of its current dot position. If the selected position
is outside the current left margin, it is forced to first column.
ESC [ \ {l} {h} {m1}...{m4}
Sets vertical units (only IBM mode).
1B 5B 5C {l} {h} {m1}...{m4} m1 = ignored
27 91 92 {l} {h} {m1}...{m4} m2 = ignored
l = 4 m3 = normally equal to 180
h = 0 m4 = normally equal to 216
This command sets the value of the vertical units. {h}*256+{l} is the number of
bytes for this command. You can set the vertical units to 1/180 inch or 1/216 inch
according to the following table:
m3 m4 Vertical Units
0 180 1/180 inch
180 0 1/180 inch
m3 m4 Vertical Units
0 216 1/216 inch
216 0 1/216 inch
ESC j
Stops printing (only IBM mode).
1B 6A
27 106
Terminator code. It then causes the printing to be stopped and the buzzer to be so
unded. The printer will be disabled to print, press the
ON LINE
/← key to put
printer online. This command has the same effect by pressing the
ON LINE
/←
key.
Appendix A
A78401745-001
A.35