User manual

134
Messages Indication Solution
BUFFER OVERFLOW
CHARACTER LOST
A buffer overflow condition
occurred (for the serial
interface).
Turn the printer off and on again, or press
the
PROGRAM
and
ON LINE
key
successively to clear the buffer.
DATA SET OFF
The DSR Signal is not
connected to the printer and
is not ready for data transfer
(if the serial interface is
selected). This condition may
happen in a remote
connection (via modem) and
the DSR (DATA SET
READY) signal is missing.
Press the
ON LINE
key to reset the error
condition.
JAM FRONT1 PATH
CHECK PAPER
A paper jam error condition
occurred in the Front1 paper
path
Check the paper path and remove the
jammed paper. Press the
ON LINE
key to
reset the error condition.
JAM FRONT2 PATH
CHECK PAPER
A paper jam error condition
occurred in the Front2 paper
path
Check the paper path and remove the
jammed paper. Press the
ON LINE
key to
reset the error condition.
NO PATH AVAILABLE
An electromechanical failure
occurs in the lower or upper
tractor paper paths.
Call Service.
NVM CHANGE
REMOVE PAPER
If this error is displayed
during the printer power on,
an NVM error condition
occurs
Turn the printer off and then on again. If
the problem is not solved call Service.