MintBox 2 Owner’s Manual
MintBox 2 Owner’s Manual December-2013 Introduction Package contents Hardware specifications MintBox 2 features Quick start guide Connecting MintBox 2 Booting Linux Maintenance Opening service door Service bay BIOS Setup Utility Warranty and RMA Warranty RMA Tips for saving power General In Operating System For more information and to obtain the latest revision of this document, please visit www.fit-pc.
Introduction Package contents 1. 2. 3. 4. 5. 6. MintBox 2 computer 12V DC power supply AC cord. Standard North-American plug * HDMI to DVI adapter 3.
MintBox 2 features Front panel The features of the front panel of MintBox 2 depend on specific FACE Module used and are documented separately. Power MintBox 2 has a tactile power push-button. It is used for turning on/off the PC and for standby/resume when supported by the operating system. A push of at least 5 seconds will always turn off the MintBox 2. Display MintBox 2 has dual display interface with support for dual head. 1. Standard HDMI with audio support 2.
WLAN 2 WLAN antennas are supplied in models with integrated WiFi and should be screwed into the standard SMA connectors. USB There are 2 USB 3.0 ports (5 Gbps) and 2 USB 2.0 ports on the back panel. All USB ports support current up to 1A. Ports on the back are upside down – note when connecting USB plugs. Depending on the FACE Module used - some models incorporate additional 4 USB 2.0 ports in the front. Serial port The RS232 mini-serial port is located on the back panel.
Quick start guide Connecting MintBox 2 Turn off the display and connect it to the MintBox 2 HDMI connector (use the HDMI to DVI adapter if needed). Connect the USB keyboard and mouse to USB 2 connectors. Plug the Ethernet cable into the Ethernet connector. In MintBox 2 models with WiFi: Mount the WiFi Antennas on the SMA connector by turning it clockwise repeatedly until the antenna holds firm. Insert the DC plug into the MintBox 2 DC-in jack. Rotate clockwise 900 to secure.
Maintenance MintBox 2 requires no maintenance. You should not take the MintBox 2 apart other than opening the service door. Taking MintBox 2 apart will void its warranty. The following operations can be conducted by the user: Opening service door 1. 2. 3. Unscrew marked Philips screw at the bottom to release service-door. Slide out service-door until it stops – about 10 mm. Service-door is now detached. Lift edge of service-door to completely remove. Re-assemble in reverse order.
BIOS Setup Utility Entering BIOS Setup Utility Turn off the MintBox 2. Turn on while holding down the F2 key. Bios Features See http://fit-pc.com/wiki/index.php/IntensePC:_BIOS_Documentation Warranty and RMA Warranty CompuLab guarantees products against defects in workmanship and material for a period of 24 months from the date of shipment. Your sole remedy and CompuLab’s sole liability shall be for CompuLab, at its sole discretion, to either repair or replace the defective product at no charge.
MintBox 2 Manufacturer: CompuLab Ltd. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Statement Changes or modifications to this equipment not expressly approved by the party responsible for compliance (CompuLab Ltd.) could void the user’s authority to operate the equipment.
