Specifications

CompuLab Ltd. IPC2 – Hardware Specification Page 29 of 83
3.6.2 System Supported Memory
 Two channels of DDR3L SDRAM memory with unbuffered Small Outline Dual In-Line
Memory 204-pin Modules (SO-DIMM)
 Up to 16GB (2x 8GB) DDR3L-1333/1600
 Single-channel and dual-channel memory organization modes
 Data burst length of eight for all memory organization modes
 System Memory Interface I/O Voltage of 1.35 V only
 DDR3L SDRAM SO-DIMMs running at 1.35 V only
 64-bit wide channels
 Non-ECC, Unbuffered SO-DIMMs only
 Theoretical maximum memory bandwidth of:
— 21.3 GB/s in dual-channel mode assuming DDR3L SDRAM 1333 MT/s
— 25.6 GB/s in dual-channel mode assuming DDR3L SDRAM 1600 MT/s
 1Gb, 2Gb, and 4Gb DDR3L SDRAM device technologies are supported
— Standard 1-Gb, 2-Gb, and 4-Gb technologies and addressing are supported for x16 and
x8 devices. There is no support for memory modules with different technologies or
capacities on opposite sides of the same memory module. If one side of a memory module
is populated, the other side is either identical or empty.
 On-Die Termination (ODT)
SO-DIMM Modules: Standard 2Gb and 4Gb technologies and addressing are supported for x8 and
x16 devices. There is no support for memory modules with different technologies or capacities on
opposite sides of the same memory module. If one side of a memory module is populated, the
other side is either identical or empty.
Table 17 – Supported SO-DIMM Memory Modules Configurations