Installation guide

Software Installation

After installing the PCI card and cables in your computer, you should restart it

and follow these steps to install the software.

Step 1. After restarting, Windows will detect your VideoMate DVB-T300/T200

and start the Add/Remove Hardware Wizard, prompting you to install

the VideoMate DVB-T300/T200 drivers. Please press Cancel and go

to the next step.

Step 2. Insert the installation CD into your CD drive. If you have Autorun

enabled, the installer will start automatically. (If Autorun is diabled,

double-click on “setup.exe” on the installation CD.) You can choose

Complete to install all necessary software (VideoMate

DVB-T300/T200 drivers, ComproDTV, Ulead PhotoExplore 8 SE and

ComproDVD) or choose Custom to select item by item. Compro

recommends you choose Complete.

Step 3. If you see the Windows Logo testing message, below, please press

“Continue Anyway” to proceed.

Step 4. Press Next to install ComproDTV, Ulead PhotoExplore 8 SE, and

ComproDVD.

Step 5. After each program is successfully installed, press Finish to proceed.

Step 6. When installation completes, press Finish to restart computer.

Continue Anyway