Installation guide

7. Plug one end of the internal audio patch cable to the green Audio-Out port

on the VideoMate DVB-T300/T200 PCI Tuner card.

8. Plug the other end of the internal audio patch cable to the AUX-In socket

on your sound card or on the mainboard. The on-board sound usually has

AUX-In and CD-In connector. Make sure you connect to the right one.

Then you have to choose the audio source to be AUX or CD-In in the

System Device in Settings of ComproDTV.

9. Verify that the power cord to your PC case is unplugged.

10. Insert VideoMate DVB-T300/T200 in an open PCI slot. Compro

recommends installing the card in the third or fourth PCI slot away from the

AGP slot.

Note

For best performance, the VideoMate DVB-T300/T200 card should not share

its IRQ. For more information, please see the Troubleshooting section.

Double Check

11. Recheck all your connections, including power and audio.

12. Before closing your PC case, plug in main power cord of the PC case. You

should see a green LED light on the PCI TV tuner card. If you don't see the

green light, please read the notes on the following page.

13. Replace the computer cover.

TV signal

14. Connect your digital or analog TV signal to the TV connector.

This completes the hardware installation. Please read the following notes and

proceed to install the software.