Installation guide

5. Connect the black socket of Power

Up patch cable to the power switch

connector on the mainboard.

6. Connect the white socket of Power

Up patch cable to the connector

named “Mainboard” on the

VideoMate DVB-T300/T200 PCI

Tuner card.

Note

Double check your work. If you plug the cables into the incorrect pins, your

PC may not start or otherwise function improperly.

Connect the white end of the Power Up patch cable to the TV tuner card and

the black end to the mainboard.

Power Up Scheduling is not required for using VideoMate DVB-T300/T200. If

you don’t want to use Power Up Scheduling from the Windows Shut down

state, you can skip the power switch circuit connections, in other words, you

can skip Power Up Connections in steps 3 through 6. You can still use

scheduled recording from Standby mode or powered on state.

Sound card connection

Digital TV sound output is through PCI bus. Therefore, the audio patch cable

connection is unnecessary if you watch digital TV only.

Analog sound (when capture from VCR or VideoMate DVB-T300’s analog TV

program) output is from the green Audio-Out port on the VideoMate

DVB-T300/T200 PCI Tuner card. You have to install the provided internal

audio patch cable in order to hear the sound.