Operating instructions
3-11 Jog Speed [Hz]
Range: Function:
Application
dependent
*
[Application
dependant]
The jog speed is a fixed output
speed at which the frequency
converter is running when the
jog function is activated.
See also par. 3-80 Jog Ramp
Time.
Application
dependent
*
[Application
dependant]
3-13 Reference Site
Option: Function:
Select which reference site to activate.
[0]
*
Linked to
Hand / Auto
Use local reference when in Hand mode; or
remote reference when in Auto mode.
[1] Remote Use remote reference in both Hand mode and
Auto mode.
[2] Local Use local reference in both Hand mode and
Auto mode.
When set to Local [2], the frequency converter
will start with this setting again following a
'power down'.
3-14 Preset Relative Reference
Range: Function:
0.00
%
*
[-100.00 -
100.00 %]
The actual reference, X, is increased or
decreased with the percentage Y, set in
par. 3-14 Preset Relative Reference. This
results in the actual reference Z. Actual
reference (X) is the sum of the inputs
selected in par. 3-15 Reference 1 Source,
par. 3-16 Reference 2 Source,
par. 3-17 Reference 3 Source and
par. 8-02 Control Source.
3-15 Reference 1 Source
Option: Function:
Select the reference input to be used
for the first reference signal.
Par. 3-15 Reference 1 Source,
par. 3-16 Reference 2 Source and
par. 3-17 Reference 3 Source define up
to three different reference signals.
The sum of these reference signals
defines the actual reference.
This parameter cannot be adjusted
while the motor is running.
[0] No function
[1]
*
Analog input 53
[2] Analog input 54
[7] Pulse input 29
[8] Pulse input 33
[20] Digital pot.meter
[21] Analog input X30/11
[22] Analog input X30/12
[23] Analog Input X42/1
[24] Analog Input X42/3
[25] Analog Input X42/5
[29] Analog Input X48/2
[30] Ext. Closed Loop 1
[31] Ext. Closed Loop 2
[32] Ext. Closed Loop 3
Parameter Description
VLT
®
HVAC Drive Programming Guide
MG.11.CA.02 - VLT
®
is a registered Danfoss trademark 49
3
3