Operating instructions

2.1.8 Parameter Selection
In the Main Menu mode, the parameters are divided into
groups. You select a parameter group by means of the naviga-
tion keys.
The following parameter groups are accessible:
Group no. Parameter group:
0 Operation/Display
1 Load/Motor
2 Brakes
3 References/Ramps
4 Limits/Warnings
5 Digital In/Out
6 Analog In/Out
8 Comm. and Options
9 Profibus
10 CAN Fieldbus
11 LonWorks
13 Smart Logic
14 Special Functions
15 Drive Information
16 Data Readouts
18 Data Readouts 2
20 Drive Closed Loop
21 Ext. Closed Loop
22 Application Functions
23 Time-based Functions
25 Cascade Controller
26 Analog I/O Option MCB 109
After selecting a parameter group, choose a parameter by
means of the navigation keys.
The middle section on the display shows the parameter
number and name as well as the selected parameter value.
2.1.9 Changing Data
The procedure for changing data is the same whether you
select a parameter in the Quick menu or the Main menu
mode. Press [OK] to change the selected parameter.
The procedure for changing data depends on whether the
selected parameter represents a numerical data value or a text
value.
2.1.10 Changing a Text Value
If the selected parameter is a text value, change the text value
by means of the [
▲
] [
▼
] navigation keys.
The up key increases the value, and the down key decreases
the value. Place the cursor on the value you want to save and
press [OK].
2.1.11 Changing a Group of Numeric Data
Values
If the chosen parameter represents a numeric data value,
change the chosen data value by means of the [
◀
] [
▶
] naviga-
tion keys as well as the [
▲
] [
▼
] navigation keys. Use the [
◀
] [
▶
]
navigation keys to move the cursor horizontally.
Use the [
▲
] [
▼
] navigation keys to change the data value. The
up key enlarges the data value, and the down key reduces the
data value. Place the cursor on the value you want to save and
press [OK].
How to Programme
VLT
®
HVAC Drive Programming Guide
MG.11.CA.02 - VLT
®
is a registered Danfoss trademark 23
2
2