Operating instructions

2.1.3 Quick Transfer of Parameter Settings
between Multiple Frequency Converters
Once the set-up of a frequency converter is complete, we
recommend that you store the data in the LCP or on a PC via
MCT 10 Set-up Software Tool.
Data storage in LCP:
1. Go to par. 0-50 LCP Copy
2. Press the [OK] key
3. Select “All to LCP”
4. Press the [OK] key
All parameter settings are now stored in the LCP indicated by
the progress bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
You can now connect the LCP to another frequency converter
and copy the parameter settings to this frequency converter
as well.
Data transfer from LCP to frequency converter:
1.
Go to par. 0-50 LCP Copy
2. Press the [OK] key
3. Select “All from LCP”
4. Press the [OK] key
The parameter settings stored in the LCP are now transferred
to the frequency converter indicated by the progress bar.
When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
2.1.4 Parameter Set-Up
The frequency converter can be used for practically all assign-
ments, thus offering a significant number of parameters. The
series offers a choice between two programming modes - the
Quick Menu mode and the Main Menu mode.
The latter provides access to all parameters. The former takes
the user through a few parameters making it possible to
program the majority of VLT HVAC Drive applications.
Regardless of the mode of programming, you can change a
parameter both in the Quick Menu mode and in the Main
Menu mode.
2.1.5 Quick Menu Mode
Parameter Data
The graphical display (GLCP) provides access to all parameters
listed under the Quick Menus. The numeric display (NLCP) only
provides access to the Quick Setup parameters. To set parame-
ters using the [Quick Menu] button - enter or change parame-
ter data or settings in accordance with the following
procedure:
1. Press Quick Menu button
2.
Use the [
▲
] and [
▼
] buttons to find the parameter
you want to change
3. Press [OK]
4.
Use [
▲
] and [
▼
] buttons to select the correct parame-
ter setting
5. Press [OK]
6. To move to a different digit within a parameter
setting, use the [
◀
] and [
▶
] buttons
7. Highlighted area indicates digit selected for change
8. Press [Cancel] button to disregard change, or press
[OK] to accept change and enter the new setting
How to Programme
VLT
®
HVAC Drive Programming Guide
16 MG.11.CA.02 - VLT
®
is a registered Danfoss trademark
2
2