Operating instructions

18-11 Fire Mode Log: Time
Range: Function:
0 s * [0 - 2147483647 s] This parameter contains an array with
10 elements. The parameter shows at
which time the logged event occurred.
Time is measured in seconds since the
first start of the motor.
18-12 Fire Mode Log: Date and Time
Range: Function:
Application
dependent
*
[Applica-
tion
dependant]
This parameter contains an array with
10 elements. The parameter shows at
which date and time the logged event
occurred. The function relies on that
the actual date and time has been set
in par. 0-70 Date and Time. Note: There
is no build in battery back up of the
clock. An external back up must be
used, eg the one in the MCB 109
Analog I/O option card. See Clock
Settings, 0-7*.
3.17.3 18-3* Analog I/O
Parameters for reporting the digital and analog I/O ports.
18-30 Analog Input X42/1
Range: Function:
0.000 * [-20.000 -
20.000 ]
Read out of the value of the signal applied to
terminal X42/1 on the Analog I/O Card.
The units of the value shown in the LCP will
correspond to the mode selected in
par. 26-00 Terminal X42/1 Mode.
18-31 Analog Input X42/3
Range: Function:
0.000 * [-20.000 -
20.000 ]
Read out of the value of the signal applied to
terminal X42/3 on the Analog I/O Card.
The units of the value shown in the LCP will
correspond to the mode selected in
par. 26-01 Terminal X42/3 Mode.
18-32 Analog Input X42/5
Range: Function:
0.000 * [-20.000 -
20.000 ]
Read out of the value of the signal applied to
terminal X42/5 on the Analog I/O Card.
The units of the value shown in the LCP will
correspond to the mode selected in
par. 26-02 Terminal X42/5 Mode.
18-33 Analog Out X42/7 [V]
Range: Function:
0.000 * [0.000 -
30.000 ]
Read out of the value of the signal applied
to terminal X42/7 on the Analog I/O Card.
The value shown reflects the selection in
par. 26-40 Terminal X42/7 Output.
18-34 Analog Out X42/9 [V]
Range: Function:
0.000 * [0.000 -
30.000 ]
Read out of the value of the signal applied
to terminal X42/9 on the Analog I/O Card.
The value shown reflects the selection in
par. 26-50 Terminal X42/9 Output.
18-35 Analog Out X42/11 [V]
Range: Function:
0.000 * [0.000 -
30.000 ]
Read out of the value of the signal applied
to terminal X42/11 on the Analog I/O Card.
The value shown reflects the selection in
par. 26-60 Terminal X42/11 Output.
3.17.4 18-5* Ref. & Feedb.
NOTE
Sensorless Readout requires set up by MCT 10 with
sensorless specific plug in.
18-50 Sensorless Readout [unit]
Range: Function:
0.000 SensorlessUnit * [-999999.999 - 999999.999
SensorlessUnit]
Parameter Description
VLT
®
HVAC Drive Programming Guide
120 MG.11.CA.02 - VLT
®
is a registered Danfoss trademark
3
3