Specifications
GETTING TO KNOW YOUR CAR
65
To cancel the set value:
❒
press the MODE button briefly: the dis-
play shows OFF;
❒
press the
▼
button: the display shows
OFF;
❒
press the MODE button briefly to re-
turn to the menu screen or press the but-
ton for a longer time to return to the
standard screen.
SPEED
With this function it is possible to set the
car speed limit (km/h) (or mph) which, if
exceeded, automatically sounds a buzzer
and displays a specific message (see chap-
ter “Warning lights and indications”).
To set the limit speed, proceed as follows:
❒
press the MODE button briefly: the dis-
play shows ON;
❒
press the MODE button briefly and
then use the
▲
/
▼
buttons to set the
speed required (during setting operation,
the value flashes on the screen).
❒
press the MODE button briefly to return
to the menu screen or press the button
for a longer time to return to the stan-
dard screen.
IMPORTANT The possible setting is be-
tween 30 and 250 km/h or between 20
and 150 mph depending on the unit set pre-
viously (see paragraph “UNITS” described lat-
er). Every press (pulse) of the
▲
/
▼
but-
ton increases or decreases by one unit. Keep-
ing the
▲
/
▼
button pressed obtains fast
increase or decrease. When you are near the
required setting, release the button and com-
plete adjustment with single presses.
DIMMER
With this function it is possible to adjust the
lighting (dimming/brightening) of the in-
strument cluster, odometer display (total and
trip meter), headlamp aiming display, radio
display, radio-navigator display (if fitted) and
two-zone climate control (if fitted).
To adjust, proceed as follows:
❒
press the MODE button briefly: the dis-
play shows a graduated scale;
❒
press the buttons
▲
/
▼
to carry out
adjustment.
❒
press the MODE button briefly to return
to the menu screen or press the button
for a longer time to return to the stan-
dard screen.
Partial lighting
Keeping the
▼
button pressed for more
than 4 seconds, the rev counter lighting is
turned off.
Keeping the
▲
button pressed for more
than 4 seconds, the complete instrument
cluster lighting is turned on again.
IMPORTANT In the event of any faults,
lighting adjustment (rheostat) is not possi-
ble and the display is shown at its maximum
brightness.
058-085_Alfa147 Q2 GB 4-07-2008 11:59 Pagina 65