Specifications

GETTING TO KNOW YOUR CAR
59
CLOCK (fig. 78)
Adjusting the hours
Press the MODE button in
Q
, the hours
will flash. Set the hour required using button
▲
or
▼
.
Every press on the button will increase by
one unit.
Keeping the button pressed obtains auto-
matic fast increase or decrease.
When you are near the value required, re-
lease the control and complete adjustment
with single presses.
Then press the MODE button in
R
to
store.
fig. 78
Adjusting the minutes
Press the MODE button twice in
Q
, the
minutes will flash. Set the minutes required
using button
▲
or
▼
.
Every press on the button will increase by
one unit.
Keeping the button pressed obtains auto-
matic fast increase or decrease.
When you are near the value required, re-
lease the control and complete adjustment
with single presses.
Then press the MODE button in
R
to
store.
OUTSIDE TEMPERATURE (fig. 79)
Outside temperature can be viewed on the
display lower side, under the hour indica-
tion. When the outside temperature is be-
low or 3° C, the indicator starts flashing
together with the buzzer, to warn the driver
about the possible presence of ice on the
road. The acoustic signal lasts about 2 sec-
onds, while the outside temperature indi-
cator flashes for about 10 seconds. The sig-
nal of possible presence of ice on the road
is repeated only if the outside temperature
is over 6° C and then reaches again 3° C.
A0A0009m
fig. 79
A0A0083m
BUZZER (fig. 79-80)
The buzzer which accompanies the con-
trols may be activated (ON) or deactivated
(OFF); proceed as follows:
Press the MODE button 3 times
Q
, then
use button
▲
or
▼
to turn the buzzer on
or off.
The press the MODE button in
R
to
store the condition chosen.
clock and
outside temperature display buzzer activated display (
ON)
058-085_Alfa147 Q2 GB 4-07-2008 11:59 Pagina 59