Specifications

Do not disperse the bot-
tle and the sealer in the
environment. Dispose of
it according to the national and
local regulations.
IN AN EMERGENCY
206
INFLATING PROCEDURE
– unscrew the tyre valve plug, take off the
filling pipe A-fig. 13 and screw the ring
nut B-fig. 14 on the tyre valve;
– make sure that the compressor switch
A-fig. 15 is in position 0 (off), start the
engine, insert the plug G-fig. 16 in the
socket/lighter on the front tunnel and
start the compressor by taking the switch
to A-fig. 15 position I (on);
– inflate the tyre to the correct pressure
value. You are advised to check the tyre
pressure value on the pressure gauge B-
fig. 15 with the compressor off, in order
to have a more accurate reading;
fig. 12
A0A1097m
fig. 13
A0A1098m
fig. 14
A0A1099m
Do not operate the com-
pressor for more than 20
minutes: risk of overheating. The
quick repairing kit is not suitable
for a final repairing, therefore
repaired tyres must be used only
temporarily.
WARNING
Wear the protective gloves
provided with the quick re-
pairing kit.
WARNING
Proceed as follows:
– place the wheel with the valve A-fig.
12 in the position illustrated in the figure,
engage the handbrake, then remove
the quick repairing kit and place it on the
ground next to the wheel;
197-233_Alfa147 Q2 GB 4-07-2008 12:04 Pagina 206