Service manual

16
CHROMOPHARE® D 650plus, D 530plus, D 500plus, D 650, D 530, D 500 Service Manual (E)
3.2.1.2 CHROMOPHARE® D 530plus, D 530
The following functions can be controlled by the control unit:
•On/off
•Intensity of illumination
Options:
•Switch over to EndoLite® surround light - switch to operating light - only with EndoLite® option
1ONSwitch on the light
2
OFFSwitch off the light
3
BrightIncrease intensity
4
DarkDecrease intensity
5
FaultLED indicates that the control unit has a fault
Options:
6
EndoLite®Switch from surgical area light to surround light (option only)
7
OP lightSwitch from surround light to surgical area light
1The OP light is switched on by pressing Key 1 (ON)
2The OP light is switched off by pressing Key 2 (OFF)
3By pressing and holding down Key 3 (BRIGHT) the illuminance is continuously increased up to the maximum
value. Repeated short presses increase the illuminance in steps.
4By pressing and holding down Key 4 (DARK) the illuminance is continuously reduced down to the minimum
value. Repeated short presses decrease the illuminance in steps.
5If the indicator light shows red, there is a fault in the control unit electronics
6Only with the EndoLite® option. By pressing Key 6 EndoLite® the surgical area illumination is switched off
and the surround lighting is switched on