Service manual

14
CHROMOPHARE® D 650plus, D 530plus, D 500plus, D 650, D 530, D 500 Service Manual (E)
3.2 Notes on operation
3.2.1 Setting the control unit functions
3.2.1.1 CHROMOPHARE® D 650plus, D 650
The following functions can be controlled by the control unit:
•On/off
•Intensity of illumination
Options:
•Electronic light field adjustment - only for LFN
•Switch over to EndoLite® surround light - switch to operating light - only with EndoLite® option
1
ONSwitch on the light
2
OFFSwitch off the light
3
BrightIncrease intensity
4
DarkDecrease intensity
5
FaultLED indicates that the control unit has a fault
Options:
6
EndoLite®Switch from surgical area light to surround light (option only)
7
OP lightSwitch from surround light to surgical area light
8
Field size largeEnlarge field size (only with LFN option)
9
Field size smallReduce field size (only with LFN option)
1The OP light is switched on by pressing Key 1 (ON)
2The OP light is switched off by pressing Key 2 (OFF)
3By pressing and holding down Key 3 (BRIGHT) the illuminance is continuously increased up to the maximum
value. Repeated short presses increase the illuminance in steps.