Operating instructions

15
CHROMOPHARE
®
D 650plus, D 530plus,D 300, C 95x Operating instructions (E)
4.2 Control Panel and symbols CHROMOPHARE
®
D 650plus
The following functions can be controlled by the control panel:
1 ON Switch on the light
2
OFF Switch off the light
3
Bright Increase intensity (the reach of the maximum intensity will be displayed by a
light emitting diode)
4
Dark Decrease intensity (the reach of the minimum will be displayed by a light
emitting diode)
5
Fault LED indicates that the control unit has a fault
Options:
6
EndoLite
®
Switch from surgical area light to surround light (option only)
7
OP light Switch from surround light to surgical area light
8
Field size large Enlarge field size (only with LFN option)
9
Field size smal Reduce field size (only with LFN option)
(ON) The OP light is switched on by pressing Key 1.
(OFF) The OP light is switched off by pressing Key 2.
(Bright) By pressing and holding down Key 3 the illuminance is continuously increased up to the maximum
value. Repeated short presses increase the illuminance in steps.
(Dark) By pressing and holding down Key 4 the illuminance is continuously reduced down to the minimum
value. Repeated short presses decrease the illuminance in steps.
Fault If the indicator light shows red, there is a fault in the control unit electronics.
EndoLite
®
Only with the EndoLite
®
option. By pressing Key 6 EndoLite
®
the surgical area illumination is
switched off and the surround lighting is switched on.