Technical data

9 / 60 HBC-series V7 LV small types profi low power
cable #1
input PWM
A
B
C
Connector ICS-2:
Connecting brake lights
+ programming
+ ext. signalization
cable #34
communication
A
B
C
TxD data from controller (red)
GND (minus), brown
RxD data to controller (orange)
cable #2
control voltage
Indication LED
abeam
)
Indication LED
abeam
)
- batt.
+ batt.
switch (only „s“ version)
to electromotor
Position „TURNED-ON“
(disconnected contacts)
„TURNED-OFF“
to electromotor
- batt.
+ batt.
+5 V for servos and receiver (red)
Control pulses (orange)
Controller version with communication and with switch Basic modification with switch
GND (minus), brown
cable #2
+5 V from BEC or external *) red
Ground, GND, minus *), brown
driving PWM, INP_1, orange
cable #34
cable #5
+3.3 V potentiometer feeding, red
ground (GND, minus), brown
Driving voltage, INP_2, orange
Transmitting Data TxD, red
ground (GND, minus), brown
Receiving Data RxD, orange
+3.3 V voltage output, red
ground (GND, minus), brown
Output signal TTL 3.3V, orange
cable #6
ground (GND, minus), brown
Battery temperature sensor, orange
Open contact = switch-on
Closed contact = switch-off
ground (GND, minus), brown
switch, red
cable #1
Safety switch - connector
Safety switch
Switch-on position
(open contacts)
cable #6 with sensor KTY81-210
Battery temperature sensor
One of the two
Basic description of the controllers
Summary of possible inputs / outputs
*) Note: in case of OPTO version is optocoupler feeds from external source and grounds (GND) are not connected together
Attention, in the telemetry case
(variant „BC“) is this cable
connection in other modifica-
tion ! see Back data transfer ….
1
2
3
4
5
6
0
# 6
# 0
# 5
# 1
# 2
# 34
# 6