Technical data

53 / 60 HBC-series V7 LV small types profi low power

8b. when procedure corrupt (communication er-

ror etc.), is displayed this message

Necessary start this update again.

7. Updating procedure

start.

8a. When procedure correctly

finished, message will

appear. Push OK.

9. Follow next instruction.

10. After restart device (your speed controller), newest version

of its firmware is displayed. Update procedure is complete.

Note:

You can start updating procedure for unlimited amount of tries, the controller cannot be broken down by failed update, but you have to finish

the update procedure without errors [8a] if you want to use it with motor or parameter settings etc.

When procedure don´t finished correctly [point 8b], controller (device) after next turn-on only slightly lights (glows) by blue LED. Controller

don´t work, not possible set parameters, etc. In this case is necessary this updating procedure repeat !

Note: Please, check also, if newest version of program „Controller 2“ isn’t available. Newest parameters or other changes, which correspond

with new version of the firmware, can be added. Without a corresponding version of program “Controller 2” settings will not work cor-

rectly!