Technical data

52 / 60 HBC-series V7 LV small types profi low power
Update SW inside the controller (firmware)
When you want make update firmware in you controller to newest available version, you need USBCOM 4 module (or in case of feeding from
power supply USBCOM 4i module – isolated version) and CC_11 cable (the same as for standard programming of parameters).
Controller must be connected to internet.
Starting sequence for firmware updating follows:
0. Connect USBCOM 4(i) module to PC and Start program Controller 2 first. Connect controller, but no turn-on yet.
1. Choice button “SYSTEM”
2. Choice “Firmware update”
3. Windows “Firmware update” open
4. Turn-on your speed controller by its switch or applying main voltage.
Your device version as well as available firmware version is displayed.
(If you already had the controller is switched on,
now it must be switched off and on again)
5. Push “Update” button release.
6. Confirm firmware updating
CC_11
0
2
1
3
5
6
Yes
No
4