Technical data

39 / 60 HBC-series V7 LV small types profi low power

View from

opposite side

to USB port in PC

connector ICS-2

CC_11

Connection cable CC_11

EFRA connector

connect to ICS-2

HBC-series controller

Detail, view „from

motor side“

connector ICS-2

Parameters setting / Data reading from controller

To set parameters or reading data from the controller, you need to connect your PC and the controller module USBCOM 4 or USBCOM 4i

(for the controller feeding from the mains power supply), the PC software "Controller 2", which is free to download from our web and on CD

and need connecting cable CC_11.

1) start program Controller 2

2) connect USBCOM 4(i) module to USB port of your PC and connect with controller by CC_11 cable (cable CC_11 is connected to ICS-2

marking connectors, in both equipment)

3) turn on controller by connect to suitable battery (and turn-on switch for version with switch)

4) now you can communicate with controller, read data, change parameters value, write changes parameters etc.

Don´t forget select memory bank first, change parameters after this. Before switch-off write parameters by button “Write setting.

Important: If the controller is feed from the battery, module USBCOM 4 is enough to connect of the controller to the PC. But if you

need use power supply for feeding the controller, you must use module USBCOM 4i, which ensure galvanic isolation of

the controller from the PC. This is necessary because a number of mains power supply (either in PC or others) is not ful-

ly correct separated from their chassis (minus their potentials, GND) and is possible measured frequently large voltage

(units to tens of volts). If you apply in this case USBCOM 4 non-insulated module, you risk damaging or destruction as

USBCOM 4 module, as well as also the controller (or USB port on your PC).

Program Window

in the PC screen:

Shift to other parameters

hidden below and up

controller type and

version

Language select

Main control

Parameter value

set as number

Select from

possibilities

parameters

setting area

„Analog“

value setting