Technical data

22 / 60 HBC-series V7 LV small types profi low power
Example: Motor by NOVAK,
Velocity 3.5R Brushless Motor
Phase A
Phase C
Phase B
connector
JST ZH
pin #1
SENSOR MOTORS:
Sensor motor according to EFRA specification:
- must have 6-pin JST ZH connector model ZHR-6 or equivalent,
marked as SZH-002TP0.5 26-28 awg. for sensors and heat sensor connection
Pins specification of this connector:
Pin #1 – black wire, ground potential (minus)
Pin #2 – orange wire, sensor phase C
Pin #3 – white wire, sensor phase B
Pin #4 – green wire, sensor phase A
Pin #5 – blue wire, motor temperature sensing, 10 k  NTC
(other end of sensor is on ground potential, pin #1)
Pin #6 – red wire, sensors feeding, +5.0 V ± 10%.
(supply voltage for sensors provide controller, don´t connect external voltage !)
- power wires are marked A, B, C – connect to phases of controller, with the same name.
A for phase A
B for phase B
C for phase C
View from „back“
from the motor
pin #1
Connector JST by EFRA:
Motor’s sensors
connection
Connector ICS-2:
USBCOM 4 connection
(to PC), brake lights
View from opposite side