Technical data

20 / 60 HBC-series V7 LV small types profi low power
Connect to corresponding connector
of transmitting module 2.4 GHz
Display unit for displaying of
transferred data from receiver side
– as from controller, sensors, etc.
- batt.
+ batt.
to electromotor
cable #1 or 2
control
A
B
C
cable #34
telemetry
+5 V for servos and receiver (red)
ground (minus), brown
+5 V for servos and receiver (red)
ground (minus), brown
data from controller (orange )
Indication LED
abeam
Control pulses (orange)
Back data transfer, telemetry (only for controllers marking „BC“).
If you need some information or data to monitor in traffic in real time, at a distance (i.e. cannot be used "Monitoring"), it is possible to use some
sets of modules for remote control and the data transfer and display their help with.
Controllers with „BC“ modification has not only general servocable #1, but also second cable #34. This cable transfer data from the controller to
receiver (and receiver transfer these data subsequently to transmitter side). This cable #34 is connected to corresponding channel of receiver
(for details see manual of receiver).
Necessary set corresponding data format, in parameter „telemetry“ by program „Controller 2“ (as for example TWIN for receivers and RC
equipment of MZK servis company or HOTT system from Graupner, etc.)
Display unit, which displayed transferred data, connect to transmitting module 2,4GHz of your transmitter.
For connection and set receiver, transmitting module and display unit follow instruction for these components.
Cable #34 modification for telemetry:
Note: BEC voltage, on the middle pin of this connector, is available only for BEC version of the controller. In case the controller without BEC
system, no voltage is present on this pin.
Connecting:
cable #34
+5V BEC, red
ground (GND, minus), brown
Bidirectional data transfer, orange
# 34
3
4
GND
+3.3V
(BEC voltage)
driving PWM
Source of the BEC (5V)
(OPTO version haven´t BEC)
supply of the receiver and servos from controller (if
BEC implemented) .
Controller HBC- series
Receiver
Receiving of input
control PWM
control PWM for controller
GND
GND
+3.3V
Data to receiver
Transmitting and receiving data
Data from receiver
100 Ω
Control PWM
(cable #1 )
Telemetry
(cable #34 )
Source of the BEC (5V)
(OPTO version haven´t BEC)
Doubled supply of the receiver and servos from
controller (if BEC implemented)
For OPTO versions is 5V supply by another
source which feed receiver as well as
optocoupler in the controller
Example of MZK unit.