User`s manual

DOCUMENTATION

There are three possibilities to document the measurement.

Save the measurement in the system memory. When a

measurement is saved in Shaft Alignment for Cardan Shafts it

is the measurement result that is stored and not the displayed

measurement after performed adjustments. To store this,

redo the measurement and then store it.

Print the result.

Export saved measurements to a computer.

RESUME FUNCTION

The Cardan Shaft Alignment program is supported by a resume function,

which stores all the necessary data temporarily. The resume function enters

when the system is shut off automatically (auto off) or when the low battery

warning is shown.

When the system is restarted after resume

a selection box appears. Touch the

Cardan Shaft Alignment icon to get back

to the saved data or touch the Main Menu

icon to cancel and go to the Main Menu.