User`s manual

Slide the TD-S unit above the target
and slide down the TD-M unit in
position in front of the target plate
Turn the TD-M unit vertically (or
horizontally) and note where the
laser spot hits the target.
Rotate the shaft of the movable
machine 180 degrees
The laser spot on the target plate of
the stationary machine will rotate in
a circle. Adjust to half the diameter
with the blue adjustment screws both
vertically and horizontally. Repeat
until the circle is one spot on the
target plate.
The difference between the laser spot
and the centre of the target is the
angular error of the movable
machine. Adjust the movable machine
both vertically and horizontally until
the laser spot is centered in the
target of the stationary machine.
Slide the TD-M unit above the target
and slide down the TD-S unit.
Rotate the TD-S unit and cone in if
necessary. The laser spot on the
target of the movable machine is now
probably off centre. If the difference
is more than 3 mm repeat the
procedure, step 7-14.
66