User`s manual

COARSE ADJUSTMENT
Mount the TD-M unit on the moveable
machine and the TD-S unit on the
stationary machine.
To ensure that the laser will hit the
target when doing the alignment we
will need to “cone in” the laser
beam.
Slide the TD-M unit above the target
Turn the TD-S unit to a vertical
position. Adjust the arm fixture to a
position where the laser beam from
the TD-S unit hits the target on the
movable machine. Note where the
laser beam hits the target.
Rotate the TD-S unit 180 degrees.
The laser spot on the target plate of
the movable machine will rotate in a
circle. The centre of this circle is the
axis rotation of the Dummy shaft.
Adjust to half the diameter with the
blue adjustments screws both
vertically and horizontally. Repeat
the coning process until the circle is a
single spot on the target plate
Adjust the arm with the TD-S unit
until the laser beam is centered in
the target of the movable machine.
65